Xlusi - xlusi.com - Machine Repair
General Information:
Latest News:
Shock Absorber Removal And Installation 27 Aug 2013 | 02:04 am
A. REMOVAL OF THE FRONT SHOCK ABSORBER (1) Jack up the front section of the vehicle and remove the front wheels. (2) Loosen the two 10 mm nuts on the upper section of the shock absorber. (3) When the ...
Electrical System Circuit Light Test Checker 26 Aug 2013 | 02:05 am
A test light is used to check the continuity of an electrical circuit. A test light utilizes a bulb held in a probe attached to a sharply pointed rod with a grounding lead. This design is optimal for ...
CASIS DAN PEMINDAH TENAGA 25 Aug 2013 | 02:04 pm
1. Bagian-Bagian Utama Sistem Pemindah Tenaga Kopling : Menghubung dan memutus putaran / tenaga motor ke transmisi Transmisi : Mengatur perbandingan putaran motor dengan poros penggerak aksel sehingga...
How to Change a Flat Tire 25 Aug 2013 | 02:04 am
Invest a few minutes in your car once a week and you’ll not only save hundreds of dollars in potential repair bills, but you’ll also understand your car better. You might decide to hire everything els...
Rear Spring Removal and Installation 22 Aug 2013 | 02:04 am
A. MEASURING REAR SPRING HEIGHT When measuring the rear spring heights, the vehicle should be placed on a level floor, have the correct front suspension height, the correct tire pressures, no passenge...
Penyetelan Sistem Cuk 21 Aug 2013 | 02:04 pm
Pemeriksaan kondisi mekanisme katup cuk Periksa gerakan bebas poros katup cuk. Pada katup cuk terbuka, harus ada gerak bebas aksial » 0,1 mm. Jika gerakan poros katup berat, kontrol tutup karburator b...
Front Damper Reassembly and Installation 20 Aug 2013 | 02:04 am
Front damper Reassembly 1. Install the damper unit, damper spring, bump stop, bump stop plate, dust cover, dust cover end, dust cover plate, spring mounting rubber, damper bushings, and collar on the ...
Governor Pneumatik 17 Aug 2013 | 02:04 pm
Governor pneumatik bekerja tergantung kevakuman didalam venturi. Kevakuman yang ditimbulkan untuk meregulasi putaran mesin » 40 – 80 milli bar. Governor pneumatik dapat meregulasi setiap putaran (puta...
Milling Machine Safety Guidelines 16 Aug 2013 | 02:04 pm
Milling Machine Safety Guidelines 1. Work must be clamped securely in a vise and vise clamped tightly to the table, or, work must be clamped securely to the table. 2. Do not take climb milling cuts on...
Pengaman sistem kemudi 14 Aug 2013 | 02:04 pm
Pengaman Pada Sistem Kemudi Sistem kemudi jenis biasa Sistem kemudi ini tidak mempunyai elemen pengaman sehingga bila terjadi kecelakaan, tidak aman bagi penumpang Perhatikan perubahan batang kemudi y...
